RESUMO
To prepare a soft magnetic powder core, the magnetic powder surface has to be insulated by phosphating treatment. Organic chemicals such as ethanol and acetone are generally used as solvents for phosphoric acid, which may cause serious environmental problems. This work proposed deionized water as the environmentally friendly phosphating solvent for FeSiCr powder. The soft magnetic composites (SMCs) were prepared using phosphoric acid for inorganic coating and modified silicon polymer for organic coating. The effect of different phosphating solvents, including deionized water, ethanol, and acetone, on the structure and magnetic properties of SMCs were investigated. It is found that the solvent affects the phosphating solution's stability and the phosphoric acid's ionization. The phosphoric acid is more stable in deionized water than in ethanol and acetone. The phosphating reaction in deionized water is also more stable in deionized water, resulting in a dense phosphate coating on the particle surface. The effects of phosphoric acid concentration and temperature on the magnetic properties of FeSiCr-based SMCs were further studied. With the increase in phosphoric acid concentration and temperature, the magnetic permeability and saturation magnetization of the powder core decrease, and the core loss decreases, followed by an increase. The optimized combination of properties was obtained for the SMCs phosphated with 0.2 wt.% phosphoric acid in deionized water at 35 °C, including a high effective permeability µe of 25.7, high quality factor Q of 80.2, low core loss Pcv of 709.5 mW/cm3 measured at 0.05 T @ 100 kHz, and high withstanding voltage of 276 V, due to the formation of uniform and dense insulating coating layers. In addition, the SMCs prepared with phosphated powder show good corrosion resistance. The anti-corrosion properties of the SMCs using deionized water as a phosphating solvent are better than those using ethanol and acetone.
RESUMO
Pressure has a significant effect on rubber seal performance in the abrasive environments of drilling. The micro-clastic rocks intruding into the seal interface are prone to fracture, which will change the wear process and mechanism, but this process is not yet known at present. To explore this issue, abrasive wear tests were carried out to compare the failure characteristics of the particles and the variation wear process under high/low pressures. The results show that non-round particles are prone to fracture under different pressures, resulting in different damage patterns and wear loss on the rubber surface. A single particle force model was established at the soft rubber-hard metal interface. Three typical breakage types of particles were analyzed, including ground, partially fractured, and crushed. At high load, more particles were crushed, while at low load, shear failure was more likely to occur at the edges of particles. These different particle fracture characteristics not only change the particle size, but also the state of motion and thus the subsequent friction and wear processes. Therefore, the tribological behavior and wear mechanism of abrasive wear are different at high pressure and low pressure. Higher pressure reduces the invasion of the abrasive particles, but also intensifies the tearing and wear of the rubber. However, no significant differences in damage were found for steel counterpart throughout the wear process under high/low load tests. These results are critical to understanding the abrasive wear of rubber seals in drilling engineering.
